The Bluetosec transmitters are the heart of the system, they transmit the radio signals to the central unit, where they are evaluated. For any type of monitoring, a Bluetosec transmitter is required, and the corresponding sensor, e.g. a magnetic sensor, or a motion detector, or water detector, etc., is used.
Up to 3 different sensors can be connected to one Bluetosec transmitter, which saves money and installation time.
3,5 x 6 x 2,4 cm (WxHxD)
The DSP-Sensor combines the function of the 2 best sensors for the monitoring, the motion detector and the light barrier. For this purpose it uses 2 independently operating sensors in one housing.
DSP stands for Dual Signal Protection, meaning that this DSP sensor can only trigger if both sensors register a movement independently of each other at the same time.
This considerably increases the safety against false triggering.
In addition, the design of the DSP sensor is designed to monitor a precisely adjustable area like a light barrier, which prevents false triggering by small animals and ensures that you can very accurately determine which areas should be monitored.
The special design and waterproof housing ensure that the DSP can be used anywhere outdoors. It's no problem if it's snowing, raining or the sun is shining directly on the sensor.
The combined PIR (Passive Infrared) sensors ensure that wobbly flowers or strangers cannot trigger an alarm in the wind. A radio signal is only transmitted if sufficient heat radiation (heat radiation) is registered by both sensors with simultaneous movement. This radio signal can be evaluated by our visitor detectors or radio sirens or alarm systems.
More information about the DSP sensor can be found in the PDF file:
Höhe: 16,0 cm
Width: 9,0 cm
Depth: 6,0 cm
Operating temperature: -20 to +40 °C
Scope of delivery:
1 x DSP motion detector
4 x Alkaline batteries type C